Message ID | 20200715011833.24600-13-laurent.pinchart@ideasonboard.com |
---|---|
State | Accepted |
Delegated to: | Laurent Pinchart |
Headers | show |
Series |
|
Related | show |
diff --git a/arch/arm/boot/dts/overlays/README b/arch/arm/boot/dts/overlays/README index 2e11964f33cb..914e9a34bdc2 100644 --- a/arch/arm/boot/dts/overlays/README +++ b/arch/arm/boot/dts/overlays/README @@ -1433,8 +1433,9 @@ Name: imx219 Info: Sony IMX219 camera module. Uses Unicam 1, which is the standard camera connector on most Pi variants. -Load: dtoverlay=imx219 -Params: <None> +Load: dtoverlay=imx219,<param>=<val> +Params: rotation Mounting rotation of the camera sensor (0 or + 180) Name: imx290 diff --git a/arch/arm/boot/dts/overlays/imx219-overlay.dts b/arch/arm/boot/dts/overlays/imx219-overlay.dts index 3c2d3fac93d2..dce07b335c4e 100644 --- a/arch/arm/boot/dts/overlays/imx219-overlay.dts +++ b/arch/arm/boot/dts/overlays/imx219-overlay.dts @@ -27,6 +27,8 @@ VDIG-supply = <&imx219_vdig>; /* 1.8v */ VDDL-supply = <&imx219_vddl>; /* 1.2v */ + rotation = <180>; + port { imx219_0: endpoint { remote-endpoint = <&csi1_ep>; @@ -110,4 +112,8 @@ cam0-pwdn = <&imx219_vana>,"gpio:4"; }; }; + + __overrides__ { + rotation = <&imx219>,"rotation:0"; + }; };
Add a rotation DT overlay parameter to allow specifying the camera module mounting rotation. Set the default rotation to 180 as the module is typically mounted upside-down. Signed-off-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com> --- arch/arm/boot/dts/overlays/README | 5 +++-- arch/arm/boot/dts/overlays/imx219-overlay.dts | 6 ++++++ 2 files changed, 9 insertions(+), 2 deletions(-)